The four torx (i.e., starnuts) that secure the crank arm to the PM are supposed to be torqued to 8NM (actually, one of the four is smaller and has a 6NM rating). I'm having difficulty getting my torque wrench in there as the socket bumps against the crank spindle, causing the torx bit to not align well. This is especially a problem with the small starnut as it's fragile and shallow.
I've managed to get them right by using an extension but it's sure awkward and I can see there's a high risk of rounding the starnuts if you're not ultra careful. The four pin fastener on my old Cannondale SRM was a way better system. I suspect clearance issues with new frames led to the new design for Dura Ace.
Anyone run into this issue? What tool do you use? Thoughts?
Technical Dura Ace 7900 SRM Question
Moderator: robbosmans
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
-
- Shop Owner
- Posts: 1980
- Joined: Sat Jun 13, 2009 4:02 am
- Location: NoVA/DC