Just my KCNC Ti skewer came in, swap them out with the OEM Mavic ones, they seems quite a bit light. But I have a few questions about the set up.
When I first use it, should I lube the lever joint?
Is there such thing as too tight when closing the lever?
For rear none lever side, seems like the Ti rod would stick out a out after the skewer is tightened, does it look normal?
(sorry for the quality of the photo, iPhone doesn't quite do a good job in low light)
KCNC Ti skewer setup question
Moderator: robbosmans
I would trim the skewer, esp if it's the front one. I do not like it when it snags and it's WW, so there is no reason not to.
Of course, you do not want to cut it too short, so if you have other frames you use the wheels on, cut it to the thickest frame.
Of course, you do not want to cut it too short, so if you have other frames you use the wheels on, cut it to the thickest frame.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
I noticed that the front isn't long enough to fully thread on the endcap when using and Enve fork. Anyone else see this?