this may seems like a silly question.
i just bought a KCNC EVA grip and i dont know how to install the end plugs. they seems to be too big for my Ritchey Superlogic flat bar (31.8 ). can i just cut off the lower part and superglue the top onto the grip end?
and also how do i remove or adjust the grip position? coz once i put it on it seems like its would just stuck there forever.
how to install grip end plugs??
Moderator: Moderator Team
If I remember correctly, the KCNC end plugs are slightly larger than most and require quite a bit of force, but you just force it inside the handlebar. You can use a rubber/plastic mallet if you absolutely can't get it in.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
-
- Posts: 35
- Joined: Sun Jul 07, 2013 7:37 pm
Just get some cheap plastic road bar caps. Weighs almost nothing...
I just use a sharp knife to cut 4 small triangles out of the 'webs' so they can fold over more when you push them in.
KCNC haven't fitted in any of my bars off the shelf.
KCNC haven't fitted in any of my bars off the shelf.
Impoverished weight weenie wanna-be!
Budget 26" HT build viewtopic.php?f=10&t=110956
Budget 26" HT build viewtopic.php?f=10&t=110956