Discuss light weight issues concerning road bikes & parts.
- Posts: 410
- Joined: Tue Aug 02, 2011 5:54 pm
Zen Cyclery wrote:
If you decide to go with one, I would say go with the medium softness.
Thanks for the info and advice.
- Posts: 315
- Joined: Thu Sep 30, 2010 5:50 am
brake cleaner or brakeleen as it is in the US will also easily remove stickers and can be bad on a lot of finishes so you have to be real careful.
I cleaned then with Window cleaner as recommended and it worked pretty well. But don't let that deter anyone from putting up their ideas or methods.
I have found Park's chain brite to work well too with a scotchbrite pad. I will usually do that when I am cleaning the bike and chain and can hose off the wheel afterwards.
- Posts: 37
- Joined: Tue Nov 09, 2010 8:02 pm
besides the brake track being cleaned with a Mr Clean magic eraser or Automotive rim cleaner, I usually give the brake pads a scrub with emery cloth to take care of any glazing that might be happening.
- Posts: 248
- Joined: Wed Dec 28, 2005 12:04 am
To get off all the black gummy material, particularly after a wet ride, I use WD-40 sprayed on a small square piece of green Scothbrite. You need some sort of petroleum distillate to dissolve the rubber, but nothing too harsh like acetone or lacquer thinner, as it can swell the tire rubber if it gets on it, besides dissolving paint or the adhesives of the wheel decals.
The Scotchrite aids in removing stubborn material quickly. You are left with a black slurry material on the rims. I remove this using isopropyl alcohol on a paper towel. This does a good job and again, you avoid using harsh solvents and it gets the rim pretty much squeaky clean.
- Posts: 51
- Joined: Sat Feb 25, 2012 4:23 am
Things to stay away from if you are at all concerned about finish.
1. Brake Cleaner will remove just about anything including paint, clear coat etc.
2. Acetone will do the same though not as quickly as brake cleaner. There's a reason why it's used to remove nail polish.
If you use any alcohol products make sure not to let is soak in the area else it will eventually eat through any finish you have.
- 13 Replies
- 1075 Views
Last post by sugarkane
Wed Jan 17, 2018 2:51 am
- 16 Replies
- 589 Views
Last post by monkeytusmc
Wed Jul 04, 2018 12:16 pm
- 11 Replies
- 686 Views
Last post by Marin
Thu Mar 08, 2018 1:53 pm
- 6 Replies
- 483 Views
Last post by Bridgeman
Mon May 28, 2018 4:56 pm
- 5 Replies
- 761 Views
Last post by DeeHubbs
Sun Nov 05, 2017 5:21 pm