How many drivers does a buggy have?
So let's just say I'm drivin' this buggy...
and if you fix your attitude you can ride along with me.
timzcat wrote:Ufgators wrote:I will weight the arms today. At least they look
Nice as I can't use them without spindle!
New arms should work on old spindle
People have suggested that spline is different. That the spindle will fit in crank arms but will have spacing problems.
Sorry for the SiSL newbie question and slightly OT, but does anyone know if these will work with a (cough) Specialized SL4 OSBB frame?
I had assumed they would, but then I read that some Specialized BB30 frames use a 61mm width (which apparently works with Specialized cranks) instead of 68mm...
Thanks in advance.
Ufgators wrote:People have suggested that spline is different. That the spindle will fit in crank arms but will have spacing problems.
Splines should be the same. There is no spacing issue if you are using the old spindle you would just install as such, not that you'd have any of the new spacers, etc.
So shoulder side on NDS and wave washer on DS. I seriously doubt it will not work. thisisatest should be able to answer this for you having held the parts.
the one very small detail i havent checked yet is to make sure the arm offset is the same as before. i doubt they changed it, but id like to be sure before someone goes out and mounts some on and smacks their chainstays every pedal stroke!
- Similar Topics
- Last post
- 19 Replies
- 2065 Views
Last post by prendrefeu
Fri Dec 29, 2017 12:07 am
- 36 Replies
- 4978 Views
Last post by BdaGhisallo
Tue Jan 23, 2018 7:41 pm
- 0 Replies
- 356 Views
Last post by alcatraz
Mon Mar 05, 2018 6:24 am
- 5 Replies
- 999 Views
Last post by eliflap-scalpel
Thu Jan 18, 2018 7:17 am
- 3 Replies
- 871 Views
Last post by Jenmoss
Wed Dec 06, 2017 11:55 pm