Moderator: Moderator Team
im just sorting out 2 di2 groupsets for my cross bikes that ive had resprayed and which i may say look fantastic.They are a custom scott scandium frame because im so tall and have long limbs i run them with easton cx90 forks.However they have no bottle cage mounts,how would you suggest i mount the battery? They run a 31.6 seat post and due to the application i dont want to highly mod them because water will undoubtedly get in.Any ideas?
away for the heavy mud and once your seat is set you do not really need access the the seatbolts unless there is slippage.
that is where i would put it and you do not have alter the frame at all
I would suggest cable tie the battery mount bracket to the seatpost. And tug it as high up as possible.
Run the main harness from the the handlebar on the toptube. And run the RD connector wire on the right seatstay.
BUT The harness may not be long enough for the FD connectors and RD connectors if run this way unless you're using a 'Large' harness on an extra-small frameset. I've not tried it that way, but it might work. Good luck!
for mounting it to the post, or even on the frame in the stock location, you can use something as simple as a pair of zefal "gizmo clamp" bottle cage mounts.
replace the hardware with aluminum or nylon for weightweenieness.
- Similar Topics
- Last post