Dale superx 2018 top cap
Moderator: Moderator Team
-
- Posts: 423
- Joined: Thu Jan 08, 2009 1:41 pm
- Location: Shetland, Scotland
I used the cover and wedge from a Cane Creek 40-Series ZS49 ZeroStack top set and that's pretty good. About 1mm step in around the headtuve, but covers the bearing and "seals" well enough.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
The top cap from cannondale part #kp058 is what you’re looking for. A bit expensive but at least you’ll have a spare headset if need be. It’s what I’m currently using and the cdale cxworld team is also using as far as I know. Perfect fit with a couple micro shims
-
- Posts: 15
- Joined: Thu Feb 21, 2013 8:51 pm
You can also use the cap from a cannondale fat cadd. That's what i have and just slam the stem
Bumping this as I just picked up a SuperX and need to slam the stem, will be looking into the Fat CAAD and the kp058 (though would rather not have to buy a whole headset for a top cap). Does anyone know if you can use the lightweight kp017 compression wedge as well? I have one on my Supersix EVO and its been fantastic and is super light.
-
- Posts: 59
- Joined: Mon Aug 20, 2018 10:04 pm
- Location: Colorado
The Cannondale KP253 is what you're looking for to slam your stem. Worked perfectly on my CAAD12 and was much cheaper than a slamthatstem.com bearing cover.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com