Dale superx 2018 top cap
Moderator: Moderator Team
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
-
- Posts: 421
- Joined: Thu Jan 08, 2009 1:41 pm
- Location: Shetland, Scotland
I used the cover and wedge from a Cane Creek 40-Series ZS49 ZeroStack top set and that's pretty good. About 1mm step in around the headtuve, but covers the bearing and "seals" well enough.
The top cap from cannondale part #kp058 is what you’re looking for. A bit expensive but at least you’ll have a spare headset if need be. It’s what I’m currently using and the cdale cxworld team is also using as far as I know. Perfect fit with a couple micro shims
-
- Posts: 15
- Joined: Thu Feb 21, 2013 8:51 pm
You can also use the cap from a cannondale fat cadd. That's what i have and just slam the stem
Bumping this as I just picked up a SuperX and need to slam the stem, will be looking into the Fat CAAD and the kp058 (though would rather not have to buy a whole headset for a top cap). Does anyone know if you can use the lightweight kp017 compression wedge as well? I have one on my Supersix EVO and its been fantastic and is super light.
-
- Posts: 59
- Joined: Mon Aug 20, 2018 10:04 pm
- Location: Colorado
The Cannondale KP253 is what you're looking for to slam your stem. Worked perfectly on my CAAD12 and was much cheaper than a slamthatstem.com bearing cover.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com