Avid shorty ultimate question please

Especially for light weight issues concerning cyclocross / touring bikes & parts.

Moderator: Moderator Team

Post Reply
fozworth
Posts: 9
Joined: Mon Aug 04, 2014 2:20 pm

by fozworth

Hi all ,I'm in the process of building a SS CX bike and am using a Cinelli Mash Work frame .Im bought a set of ASU brakes and started to follow the intalation procedure last night.As it's been some time since I've had cable brakes being a seasoned MTBer and running hydro brakes for years I'm now a tad rusty on the cable install/setups.
My question relates to the amount of play that the brake arm has on the canti stud. As my studs are retro fit (in case you want your SS to be brakeless) you have to choose one of the 2 washers provided in the kit that sit on the end of the canti stud.I had to use the plastic ones as my stud measured 22mm.
With the washer in place there is just a slight tip of the canti stud protruding .Is this correct . Secondly when I tighten up the mounting bolt the cantilever still wabbles a little bit .should it rock a little bit ?and does that go when the spring is preloaded ?
Finally I'm running H plus Sons architype rims which are 23mm wide and I'm using the brakes in the narrow setting .will I need the yellow narrow type brake block and holder kits .
Cheers
Ja

User avatar
Juanmoretime
Administrator
Posts: 7062
Joined: Sat Jun 19, 2004 11:08 am
Location: Urbana, Illinois

by Juanmoretime

I run the same brake on my cross bike in the narrow position. They were very simple to set u. I can't answer your question since I run Stans 340 rims which are narrow.
RESIDENT GRUMPY OLD MAN.


Post Reply
  • Similar Topics
    Replies
    Views
    Last post