Non-Campy Crankset/Chainrings with Campy 12 Speed

Discuss light weight issues concerning road bikes & parts.
Post Reply
maxwelllarson
Posts: 1
Joined: Mon Aug 20, 2018 7:58 pm

by maxwelllarson

Long story short - I am building up a S-works SL6 UL, trying to go a bit ww, but not crazy ww with this one. I was planning on a 1X12 drivetrain (THM SE crankset set up with a Wolf Tooth 50T Cyclocross Dropstop 1X12 compatable chainring), however after install, it became quickly apparent this will not work (chain drops on the stand).

Anyway - I am now going back to a 2X12 setup with this build. I would like to keep my THM SE (if possible), but am unsure if I will run into similar problems. I did read on here recently that RyanH sucessfully used some Praxis 10/11 sp rings on a THM SRM with Record 12 - so I am hopefull. Has anyone else used a non-campy crank and rings with 12 sp and had similar sucess?

Thanks!

by Weenie


bruno2000
Posts: 854
Joined: Fri Jun 17, 2005 4:11 pm

by bruno2000

I have used a Rotor 3d+ and Rotor 3d InPower with 12speed Campagnolo EPS and mechanical groupsets with so-called 11speed Rotor Q-rings without any issue.

Post Reply
  • Similar Topics
    Replies
    Views
    Last post