The clip on the headtube is a little loose while the other side is very tight which i didn't remove as i thought it is glued onto the frame.octave wrote: â†‘Mon Mar 25, 2019 8:29 pmknightskid wrote:Yup there is. The fitting is just nice for brake housing. Without the clip, will feel loose and cause rattling when bike going through rough road.
have you tried to remove the clips since having them installed? that is my concern: how to get them back out because they are very tight!
Sent from my iPhone using Tapatalk
When i first got my frame, i do thought that internal should be just cable, so i cut the brake housing and put in an end-cap for the headtube, then i slot in the cable and out from the other side with another end-cap for brake housing to the brake caliper. While trying to pull the cable tight, the clip on headtube went into the frame, tried multiple times, still the same problem. Look at the other side, the clip was tight, so i thought it should be glued. End up i just bring to local bike shop and have them do it since i don't have any glue that can do the job, when i got my bike back, the brake housing is going through internally and out till the brake caliper.