Page 1 of 1

PF30 conversion for Parlee Z-Zero

Posted: Mon Jan 28, 2019 11:26 am
by markcp
Hi,

I've recently got a Parlee Z-Zero and trying to find the best bb for use with internal DI2 wiring. I wanted to use a conversion type bb as I prefer this solution from an engineering point of view (screwed cups make more sense). However, I've tried a Praxis conversion BB and can't see how I'll feed the wires through the holes in the sleeve.

The issue is that the internal diameter is a constant 46mm so I need a bb which has a reduced diameter in the centre sleeved section to allow the wires to pass.

I'm sure I'm not the first to do this, so what solutions have others used?

Thanks,

Mark

PF30 conversion for Parlee Z-Zero

Posted: Mon Jan 28, 2019 11:26 am
by Weenie