Carbon grip paste on lever clamps

Discuss light weight issues concerning road bikes & parts.
Post Reply
mike001100
Posts: 99
Joined: Sun Dec 04, 2016 10:26 am

by mike001100

Hi,

I have an AX4200 bar and it doesn't have any "grip" sections for lever clamps... the bar also says 4 NM max. When I torque the clamps to approx. 3.8Nm, if I hit a medium sized dip in the road at speed, one of the levers moves as I lean on it... so, can I apply grip paste on the clamp, or is this not a good idea?

Thank you.

User avatar
Calnago
Posts: 6598
Joined: Sun Nov 07, 2010 9:14 pm

by Calnago

If it’s moving at 3.8Nm and the bar states a max clamp torque of 4Nm, then yes, I’d try some carbon paste along with it. But I’d rather have bars that are more robust to start with. The recommended torque on Campy levers is still 10Nm, which I think is a huge amount, but they do have the caveat of following the bar manufacturers recommendations first and foremost. 4Nm does seem a little low for that application however, but if that’s what they’re stating... proceed at your own risk.
Colnago C64 - The Naked Build; Colnago C60 - PR99; Trek Koppenberg - Where Emonda and Domane Meet;
Unlinked Builds (searchable): Colnago C59 - 5 Years Later; Trek Emonda SL Campagnolo SR; Special Colnago EPQ

by Weenie


sungod
Posts: 1669
Joined: Fri Dec 24, 2010 9:37 pm
Location: it's raining, it must be uk

by sungod

as above, 4 seems low, if the bars are that touchy i'm not sure i'd want to ride them

assembly paste shouldn't hurt

you could also email ax and see if they have advice for your specific levers

User avatar
4ibanez
Posts: 509
Joined: Sun Oct 05, 2014 4:54 pm
Location: Norwich, UK
Contact:

by 4ibanez

I've never experienced slippage with these bars over the last 3 years, while I've had them on my weenie bike. I'm currently using Schmolke clamps, and have been since Feb - I can't remember what I tightened them to, but no more than 3nm. They're a ridiculously tight fit, which probably helps with them not slipping.

Are you putting a lot of weight on the front end over the rough stuff?

I tend to use a little carbon paste, which should help like Cal said.

Post Reply
  • Similar Topics
    Replies
    Views
    Last post