Page 2 of 2

Re: Brake bleeding done right??

Posted: Mon Jun 18, 2018 9:49 pm
by CallumRD1
That is only necessary if you squeese the lever with nothing between the pistons. This causes them to not retract fully causing severe brake rub when you insert a rotor. If you did your bleeding with the bleed block in place, then this will be unnessary. The brakes may need a few squeezes to adapt to the thickness of your rotor, but that should be sufficient to fix the pad to rotor spacing.

Re: Brake bleeding done right??

Posted: Mon Jun 18, 2018 9:49 pm
by Weenie