Potenza rear mech pivot spring fail ;-(
Posted: Fri May 11, 2018 8:47 pm
3 month old Potenza rear mech has done no more than 500 miles has lost its tension from the main pivot (where it fixes to the dropout)
Last time I rode this bike it was fine, I was just sticking some wheels in it tonight and found the mech all floppy. I popped out the pivot and spring expecting to find a sheared spring locating peg but all looked ok. So I reassembled and it all went together as it should but when tested it goes with a ‘twang’ and tension is gone. There is so little room in the housing for the spring to move laterally I can’t see how it’s happening!
Anyone had this with Potenza or other Campag models?
I’m hoping the shop will replace due to it being so new as my fave bike is off the road.
Not happy Campag, not happy at all!
Last time I rode this bike it was fine, I was just sticking some wheels in it tonight and found the mech all floppy. I popped out the pivot and spring expecting to find a sheared spring locating peg but all looked ok. So I reassembled and it all went together as it should but when tested it goes with a ‘twang’ and tension is gone. There is so little room in the housing for the spring to move laterally I can’t see how it’s happening!
Anyone had this with Potenza or other Campag models?
I’m hoping the shop will replace due to it being so new as my fave bike is off the road.
Not happy Campag, not happy at all!