this looks like a pawl freehubongbenghui wrote: ↑Sun Apr 15, 2018 9:37 amThis is the pic of the bearings and other stuff in the hub.
In order... 6802, C-clip, ALU spacer, 6902.
DO watch out for the C-Clip as it is quite difficult to remove it. You will definitely need a C-Clip piler.
I have since replace the bearing with NTN LLB.
for lw i think they are all star ratchet, the internals are similar but not quite the same, there's no c-clip, but there is steel split ring at the back, i always assumed it is there as an end stop for the star nut and to avoid wear between the ratchet spring and the body shell, no need to remove it when changing bearings
i found a picture were it's just visible...
http://www.mlwheels.com/wp-content/uplo ... b-guts.jpg
- took off first the outer bearing by pressing it out
- spacer came off as well
- I was expecting to find any C-clip but there was nothing like that; finally understood the inner bearing was just pressed in from the inside of the wheel (opposite than the outer bearing)
The bearings are 6802 both of them.
Those are the right size, yes, but they are garbage.RyanH wrote:These should be the right ones for DT240 freehubs. The manual is kinda poor at stating which size is for the freehub itself:
https://www.ebay.com/itm/2-Pcs-Premium- ... 2749.l2649
I wouldn’t put anything but NTN, NSK, FAG or SKF in a free hub.
Sent from my iPhone using Tapatalk
- Similar Topics
- Last post
- 2 Replies
- 465 Views
Last post by octave
Tue Aug 15, 2017 10:47 pm
- 3 Replies
- 252 Views
Last post by rasmusic
Sat Feb 03, 2018 8:25 pm
- 2 Replies
- 492 Views
Last post by jlok
Sun Oct 22, 2017 2:20 am
- 1 Replies
- 437 Views
Last post by calumfindlay
Fri Aug 25, 2017 6:33 pm
- 8 Replies
- 837 Views
Last post by stormur
Sat Oct 14, 2017 1:31 am