Sram Red Quarq + rotor BSA30 Spacers?

Discuss light weight issues concerning road bikes & parts.
Post Reply
RazorL
Posts: 39
Joined: Fri Nov 28, 2014 1:31 pm
Location: Flanders, Belgium

by RazorL

Hi everyone,

I bought a used Sram Red Quarq to use with my Dengfu FM029.
The frame is with a BSA BB so i went along and bought a Rotor BSA 30 Bottom bracket.

The install went well buth i can't seem to find the amount of washers to use on either side of the crankset.
When i bought it, it came with 2 aluminum washers and a wavey washer.
At this moment i installed it with only the wavy washer on the NDS. It spins freely and doesn't seem to have some play on either side.
Still i am wondering if this is the correct installation. I found some information on the internet buth it's very mixed about my crank, a real Sram BB30, rotor Cranks...

Can someone here give me some good advice.

Fyi this is the crank i have: https://www.sram.com/sram/road/products ... r-10-speed

by Weenie


RazorL
Posts: 39
Joined: Fri Nov 28, 2014 1:31 pm
Location: Flanders, Belgium

by RazorL

No one has a clue?
Emailed quarq, hope they can sort it out.

Post Reply
  • Similar Topics
    Replies
    Views
    Last post