Cable routing problem on Cube Litening frame

[long19000]

I've just got my 2016 Cube litening c68 teamline frameset.
However, the're just two holes on the headtube cable entries, cable housing with ferrule can go straight through.
There is nothing holding them.
Am I missing some parts? HELP
Thanks.

[sharkman]

You’ll need two black cable stops fitting the holes for the canbles


Verzonden vanaf mijn iPhone met Tapatalk

[kode54]

some frames have a pass through for the entire cable housing. it looks like that. holes that accommodate cable stops are much larger...at least what i've seen.

[wheelbuilder]

You should a small plastic bag somewhere with all the frame bits included. Unless you accidentally threw it away.

[sharkman]

This is how it looks installed
If i remember well there are two small black cable stops




Verzonden vanaf mijn iPhone met Tapatalk

[sib]

I can't help you with the cable stops, but I'm very interested in a frame and fork weight!

[long19000]

54cm Frame with hanger and cable guide (except those missing! ), without bottle cage bolts, seat clamp weights 942g
Uncut fork weights 322g

Thanks for all your help!

[happyon2wheels]

I've just got my 2016 Cube litening c68 teamline frameset.
However, the're just two holes on the headtube cable entries, cable housing with ferrule can go straight through.
There is nothing holding them.
Am I missing some parts? HELP

Don't know if you solved the issue, but I recently built up exactly the same frame. There is a built-in cable housing stop in the headtube, it just sits a bit deep. The only place you will need to insert a small plastic stop is the exit of the rear brake cable from the toptube and the exit of the two derailleur cables (but that should all be included in the frame.