New cannondale SYSTEMSIX road frame!

[tommyg76]

CAAD - That's interesting to hear, do you mind me asking whereabouts you are based? Is this this the Dura Ace version?

[wingguy]

Which country are you in?

[tommyg76]

I'm based in Princeton, NJ

[CAAD8FRED]

CAAD - That's interesting to hear, do you mind me asking whereabouts you are based? Is this this the Dura Ace version?

Hollywood, Florida

[Knokkelhaug]

Have got my new SystemSix Ultegra. It is far better than expected! Even with original Fulcrum wheels and 23mm Vittoria it feels comfortable. The geometry is relaxed and the handlebar fits me well. Power transmission and stability are quite similar to SuperSix Himod. I have also tested the bike with 28mm tubeless. It's feels like a race version of synapse . The black/ red colored frame gives a lot of attention and positive feedback, same with the frame design. Recommended!

[Knokkelhaug]

I can't find a usermanual for this bike. Has anyone a link to share?

[DamonRinard]

I can't find a usermanual for this bike. Has anyone a link to share?

Hi Knokkelhaug,

Normally manuals come with your bike. There should be two: the general owner's manual, and the SystemSix Owner's Manual Supplement (OMS). Can you check with your dealer?

Also, both will eventually be on the Cannondale.com website under Support, here:
https://www.cannondale.com/en/USA/Suppo ... nuals/Road

I just checked. The general owner's manual is there, but the new OMS for your SystemSix is not there yet.

Cheers,
Damon

[Knokkelhaug]

I will contact the dealer. Thank you for quick respond!

[wingguy]

I'm based in Princeton, NJ

Ok. I can't say for sure because I'm in a different market but there should be shops where you are with HM bikes. For us, the HM DA DI2 bikes we pre-ordered are due in a week, but anything ordered now will roll over to the second production which is going to be january/february time.

If you call or email Cannondale USA they would probably be able to tell you which shops in your general area had pre-orders of the bike you need?

[candycycles]

Hi,
We have few bikes HiMod Systemsix
Which size you are looking?

[refthimos]

Hi-Mod DA or Ultegra?

[tommyg76]

Hi-Mod DA - 56

[wingguy]

...
Cheers,
Damon

Hi Damon - gonna hijack this thread for a couple of Superslice questions if that's ok!

First, the website has the crucial max/min pad stack and reach co-ordinates shown on the Geo diagram as measurements P,Q,R,S, but the chart hasn't been populated with the numbers, can your web guys get that data up?

Second, since the frame was presumably designed before the SystemSix, can it fit the same Knot 64 wheels or might it be too narrow? If it does fit, would they be as fast in the Slice as the Six, i.e. one of the best upgrade options for the DI2 model?

Thanks!

(BTW the Etap model page makes several references to a 12x148 rear hub. I'm assuming that's a typo and not the first sighting of road boost in the wild )

[mrlobber]

^^^ this. Curious to know as well.

[CAAD8FRED]

Hey Damon
A little unrelated to the SystemSix

In most independent tests the Scott Foil is right with the Venge and Madone, what happened in your wind tunnel tests that caused it to slip so low?

Rob