Chain pin protrusion
Posted: Sun Nov 19, 2017 6:18 pm
Hi,
need a little bit of advice... first time I was putting together a chain and I inserted the new pin just a little too far... (say 0.1 mm), so it is protruding... It does not seem to be interfering with anything (since I followed the Park Tool advice, I inserted the pin from the inside towards the outside, so the protrusion does not catch on the cassette or any other parts).
What should I do about it? Let it be? Remove the pin and insert a new one (or is that a big no no?) Drive it backwards slightly?
Thanks.
need a little bit of advice... first time I was putting together a chain and I inserted the new pin just a little too far... (say 0.1 mm), so it is protruding... It does not seem to be interfering with anything (since I followed the Park Tool advice, I inserted the pin from the inside towards the outside, so the protrusion does not catch on the cassette or any other parts).
What should I do about it? Let it be? Remove the pin and insert a new one (or is that a big no no?) Drive it backwards slightly?
Thanks.