Rotor 3D+ change shaft

Discuss light weight issues concerning road bikes & parts.
Post Reply
Posts: 19
Joined: Sat Feb 06, 2016 11:13 am
Location: Bavaria

by Erwin

Is it possible to change the shaft from Rotor 30mm crank? I have a MTB 3D+ left and want to use it on a road bike, but the length of crank shaft is about 10mm longer than road version (q-factor would be very bad, especially on a BB30 68mm)? So, is the shaft glued to the non drive crank arm or can you open the "star-nut" on the non drive side?

by Weenie

Posts: 30
Joined: Fri Aug 01, 2014 8:19 pm

by dfischer1

Pretty sure it's pressed and bonded in.

Post Reply
  • Similar Topics
    Last post