DI2 - no shift mode

Discuss light weight issues concerning road bikes & parts.
Post Reply
Oliveriles
Posts: 2
Joined: Sun Sep 24, 2017 5:16 pm

by Oliveriles

I use to be able to shift modes between manual, Semi and fully sync by a quick double press on the control box fitted under my stem.

Now, it does not work at all, if I press and hold it flashes as you would expect if you were going to tweek the rear derailleur settings, but a double press (quick or slow) does nothing, no lights, nothing

Checked all firmware is up to date

Checked on the e-tube software S1 and S2 for semi and fully sync are defined and on the bike by pulling the file over from the bike to the pc.

Created a new S1 and S2 semi/full sync and pushed it to the bike

No difference.

As I said it did use to work

What else can I try?

TurboKoo
Posts: 455
Joined: Wed Oct 29, 2008 7:55 pm

by TurboKoo

It’s double click that changes shift modes.
Scott Foil
Shimano 9150
Shimano FCR-9100-P
Shimano C60 tubulars

by Weenie


Oliveriles
Posts: 2
Joined: Sun Sep 24, 2017 5:16 pm

by Oliveriles

Yep - double - nothing happens

Post Reply
  • Similar Topics
    Replies
    Views
    Last post