Thread together BB for BBRight

[morganb]

Are there any thread together options that will work for BBRight? Using 3D+ cranks. All of them seem to be PF30 and I imagine wouldn't work as intended in a wider shell. The Rotor BB in my S3 is creaking badly and always felt bound up from the beginning.

[bikerjulio]

Works for both PF30 and BBright http://wheelsmfg.com/bottom-brackets/bbright/bbright-out-bottom-brackets/pf30-threaded-angular-contact-bb-black.html

[morganb]

Works for both PF30 and BBright http://wheelsmfg.com/bottom-brackets/bbright/bbright-out-bottom-brackets/pf30-threaded-angular-contact-bb-black.html

Thank much, I already have the Wheels BB tool so this is doubly good.

[SMITHERS]

This should work for you as well:

https://www.endurobearingsonline.com/co ... 5-bearings

[dlud]

I use the Wheels Mfg screw together bb on my Cervelo P5 with a Rotor 3D+. Love it. Easy to install and so far it has resolved the bearing issues that I had with the pressfit bb.

[audiophilitis]

https://fairwheelbikes.com/thm-road-bottom-brackets/

These are BBRight spec and thread together. Not sure if they work with 3D cranks but worth looking into.

[Stueys]

Not thread together but I put a cbear bb in my r5 after struggling with the rotor ones and it’s been absolutely rock solid

[hodag1977]

This should work for you as well:

https://www.endurobearingsonline.com/co ... 5-bearings

I have this same BB on my Cervelo R3 and it's been great. Nice thing about the xd-15 is it's easy to remove the ball bearings from the cups, clean, and lubricate - in my opinion, this is by far the biggest cause of noisy bottom brackets, i.e. dirty, wet, unlubricated bearings. I also wrap some teflon tape around the cups, along with some Morgan Blue Aquaproof Paste. The Enduro website/Youtube channel has a video on removing and cleaning the bearings on an xd-15 BB.

[stevod]

I'm using the Wheels BBright BB:
http://wheelsmfg.com/bottom-brackets/bb ... black.html

No problems at all.

S

[kzy090]

Rotor and Enduro have those, too.