Drilling my Carbon Handle Bars
Posted: Tue Aug 01, 2017 3:17 am
So I have made up my mind I'm going to drill a hole in my Pro Vibe Carbon bars. I'm looking for advice on where to drill? What I'm not looking for is the "you're gonna die" comments.
I'm installing the new RS-910 A junction and need to get a wire to from inside the bar to outside the bar. My drilling locations options are:
A: 30 mm from the bar end, on the side of the bar
B: At the shifter mount where the carbon is reinforced, on the inside of the bar
C: Under the tops where there is a internal channel to run the brake cables.
I spend most of my time in on the hoods or tops, dont ride on the drops often, and never a deep grip near the bar ends.
I'm leaning to drilling near the bar ends. I will only be drilling one side of the bar if that matters.
I'm installing the new RS-910 A junction and need to get a wire to from inside the bar to outside the bar. My drilling locations options are:
A: 30 mm from the bar end, on the side of the bar
B: At the shifter mount where the carbon is reinforced, on the inside of the bar
C: Under the tops where there is a internal channel to run the brake cables.
I spend most of my time in on the hoods or tops, dont ride on the drops often, and never a deep grip near the bar ends.
I'm leaning to drilling near the bar ends. I will only be drilling one side of the bar if that matters.