Ax Lightness Vial Evo Frame & Morpheus Crankset, rubbing at the BB

Discuss light weight issues concerning road bikes & parts.
Post Reply
Posts: 41
Joined: Sat Apr 24, 2010 3:20 am


Hi Everyone,

Recently finished building my Vial Evo R with the Morpheus crankset & took it out for a 20 mile spin.

After the ride, I took off the crankset and noticed on the non drive side, that the cranks were rubbing at the outer edges of the BB. I used a 1mm shim on the the drive side (no signs of rubbing) but not on the non drive side. I'm assuming in this case that I should had as well, right?
Prior to the above comment, I also I put a wavy washer on the non drive side, but the free spinning of the crankset was none existent, so I removed it.

If any of you guys out there have any suggestions or ran into the same predicament, please let me know how I can resolve this.

Thanks everyone!

by Weenie

Post Reply
  • Similar Topics
    Last post