THM Clavicula SE installation

Discuss light weight issues concerning road bikes & parts.
Post Reply
Posts: 2
Joined: Thu Feb 04, 2016 12:27 pm

by adamdoc12


Just received a new THM clavicula se crank, the crank arm was installed when i received it and i cannot get it off the spindle, i've removed the pinch bolt and adjustment bolt but it's not moving at all, am i missing something or doing something wrong?
clavicula se.jpg

Posts: 1890
Joined: Sat Jul 20, 2013 6:11 pm

by spdntrxi

Should slide off at that point.. lightly tap with rubber mallet maybe

by Weenie

User avatar
Posts: 719
Joined: Mon Jan 30, 2006 1:48 am

by jimaizumi

spray some degreaser into the contact points and lightly tap the crankarm away from the spindle.
THE PAST: 2005 C'dale R700, 2006 Spesh S-Works Tarmac Gerolsteiner, 2009 Pinarello Dogma FPX My Way, 2011 Time RXR VIP

THE PRESENT: 2016 Colnago C60 ST01, 2017 Wilier Cento 10 Ramato, Cinelli Gazetta

THE FUTURE: :mrgreen: :mrgreen:

User avatar
Posts: 505
Joined: Sun Oct 05, 2014 4:54 pm
Location: Norwich, UK

by 4ibanez

It's a bit of a PITA to get off the spindle I've found. Keep at it, you'll get it off the spindle eventually. Give it a jiggle, also you can probably treat it a bit rougher than you think!

Posts: 509
Joined: Sun Jul 29, 2012 12:49 am

by audiophilitis

Rubber mallet is your friend. The cranks are not as fragile as they seem -- they can take some pounding of a rubber mallet. Wrap the mallet with a towel for extra protection against scratches

Post Reply
  • Similar Topics
    Last post