What dimension circlip pliers for Ultra Torque?

Discuss light weight issues concerning road bikes & parts.
Post Reply
Posts: 67
Joined: Tue Jun 24, 2008 6:44 pm

by mm1

About to have my first go at replacing Ultra Torque bearings, any tips on removing the circlip? What tool do I need?

User avatar
Posts: 1901
Joined: Fri Dec 11, 2009 10:38 pm
Location: Welland, Ontario

by bikerjulio

I just held one end and pushed on the other with a small screwdriver to get the removal started.

Or you could buy a circlip tool.

There's a youtube vid for the process. http://www.youtube.com/watch?v=EJ7VlQkCT9M

you need the correct puller and installation tool.

Video shows replacing the seal, but since I didn't get seals, I've left the old ones in place
There's sometimes a buggy.
How many drivers does a buggy have?


So let's just say I'm drivin' this buggy...
and if you fix your attitude you can ride along with me.


by Weenie

Posts: 600
Joined: Mon Jan 02, 2006 7:10 pm

by ghisallo2003

Yep. Small screwdriver for me too.

Only thing to take note of is the direction of the seal, which I seem to recall getting upside down !

Post Reply
  • Similar Topics
    Last post