Page 2 of 2
Re: Is your Deda bar tape long enough?
Posted: Wed Feb 27, 2013 12:30 am
by fdegrove
Hi,
Is DEDA tape actually shorter than any other brand? If so then I haven't noticed it. To me it's one of best made out there and yes, logo's (in the right place) should be visible.
They're part and parcel of the pride of ownership. Nobody wants a a Lambo without that raging bull, right?
Ciao,
Re: Is your Deda bar tape long enough?
Posted: Wed Feb 27, 2013 1:06 am
by bmxbandit
^ It doesn't seem any shorter than other brands, on a 42 I'd usually cut around 20-30cm each side, but I would say it's quite thin. I rate pro slightly ahead as its a little softer though less hard wearing. DSP is lovely too, but much more costly.
Re: Is your Deda bar tape long enough?
Posted: Wed Feb 27, 2013 1:06 am
by Weenie
Visit
starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
Re: Is your Deda bar tape long enough?
Posted: Wed Feb 27, 2013 1:36 am
by Getter
Never payed attention to the logos on bar tape. I run the 3.2 DSP now which has no logos.
Re: Is your Deda bar tape long enough?
Posted: Thu Feb 28, 2013 7:03 pm
by PSM
Re: Is your Deda bar tape long enough?
Posted: Sun Mar 03, 2013 4:12 am
by kman
Never had a problem on 40 or 42cm bars although I haven't wrapped anything larger. Didn't seem shorter than normal to me.
Re: Is your Deda bar tape long enough?
Posted: Sun Mar 03, 2013 11:37 am
by PSM
As you can see on my picture it was no problem...
Re: Is your Deda bar tape long enough?
Posted: Mon Mar 04, 2013 9:43 am
by elviento
Never had a problem. In fact I usually end up with 3 inches of excess. Done on Newton shallow.
