Page 1 of 1
Fulcrum and Campy freehub compatibility?
Posted: Thu May 17, 2012 8:15 pm
by SW
Anyone know if you could put the freehub body from a set of campy neutron or zonda wheels on a set of fulcrum racing speed? I'm looking into a set of fulcrums but would need to change for a campy freehub and I've got a few pairs of neutrons and sinews laying around. Anyone try this?
Re: Fulcrum and Campy freehub compatibility?
Posted: Thu May 17, 2012 11:09 pm
by brearley
fulcrum zero, 1,3, speed and light use the same freehub as campagnolo neutron, shamal, eurus, bora and possibly zonda
fulcrum hubs are the same as campagnolo, the more expensive use a 15mm axle whereas cheaper use a 12mm axle
Re: Fulcrum and Campy freehub compatibility?
Posted: Thu May 17, 2012 11:09 pm
by Weenie
Visit
starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
Re: Fulcrum and Campy freehub compatibility?
Posted: Fri May 18, 2012 12:49 am
by fdegrove
Hi,
17mm and 15mm respectively actually.
Even old style 17mm inner diameter Campa bodies with the fully round spindle hole will go onto new style squared off (lobed) spindlesbut not the other way around, i.e. new bodies won't fit an old style spindles.
Ciao,
Re: Fulcrum and Campy freehub compatibility?
Posted: Fri May 18, 2012 6:37 am
by SW
Thanks guys, that's what I expected...I'll give it a go!