Zipp Vuka Sprint......

Discuss light weight issues concerning road bikes & parts.
Post Reply
Minossc
Posts: 1
Joined: Wed May 09, 2012 9:49 pm

by Minossc

Hey guys,

I know its a long shot but I am wondering if anyone has had to widen the holes on a Zipp Vuka Sprint bar in order to accomodate internal wire routing for Di2 satelite shifter. I guess I need to know whether is feasible as this bar is not meant to be taped fully and I had to tape mine as the satelite shifter wire does not fit. I now know a guy that has the tools to manipulate carbon but i dont want to have them taken out if it can not be done for one reason or another. Thanks :)

artray
Posts: 1365
Joined: Fri Oct 07, 2011 2:08 pm

by artray

I would not touch them .

Holiday
Posts: 70
Joined: Thu Jul 24, 2008 12:50 am
Location: FAR EAST
Contact:

by Holiday

Minossc wrote:Hey guys,

I know its a long shot but I am wondering if anyone has had to widen the holes on a Zipp Vuka Sprint bar in order to accomodate internal wire routing for Di2 satelite shifter. I guess I need to know whether is feasible as this bar is not meant to be taped fully and I had to tape mine as the satelite shifter wire does not fit. I now know a guy that has the tools to manipulate carbon but i dont want to have them taken out if it can not be done for one reason or another. Thanks :)


We did it on a couple of our bikes and to date no equipment failure. Have not tried mounting
a satelite shifter yet but I think it can be done if we remove the exit plug below the bar.
Attachments
VukaSprint Di2 Installation 000.jpg
VukaSprint Di2 Installation 0000.jpg
VukaSprint Di2 Installation 00000.jpg
NA

Post Reply
  • Similar Topics
    Replies
    Views
    Last post