Page 1 of 1

Chris King BB compatibility

Posted: Tue Mar 13, 2012 12:24 pm
by ekimeno
I'll very likely be wanting to build up a bike with the following:

Kuota Kharma frame
Chris King BB - one of these: http://chrisking.com/bottombrackets/bottom_bracket
Campagnolo Centaur Ultra-Torque 10-speed drivetrain

As I need both a compact chainset and one that works with CK, I'm going to have to toss my current standard UT chainset/BB cups in favour of a CK compatible one (24mm crank spindles) - question is, what compact chainset options do I have that will be compatible with both the CK BB and a Campag 10-speed chain?

TIA

Mike

Chris King BB compatibility

Posted: Tue Mar 13, 2012 12:24 pm
by Weenie

Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓    Broad Selection ✓    Worldwide Delivery ✓

www.starbike.com



Chris King BB compatibility

Posted: Tue Mar 13, 2012 12:41 pm
by Kastrup

Re: Chris King BB compatibility

Posted: Tue Mar 13, 2012 12:53 pm
by musket
If you use Stronglight 10/11s speed rings, you can use any 130bcd crank out there. Of the decent 24mm ones, there's Rotor, FSA, Shimano and others.

Re: Chris King BB compatibility

Posted: Tue Mar 13, 2012 11:38 pm
by ekimeno
Thanks, so basically something like an FSA Gossamer Pro MegaExo Compact Chainset would be compatible with the CK BB, but not with the Campag chain? I'd need to fit something like the Stronglight Dural 5083 110mm Shim 9/10 Chainring to the FSA chainset in order for the Campag chain to work?

...or is it the Stronglight Zicral 7075 110mm Camp 9/10 Chainrings?

Re: Chris King BB compatibility

Posted: Mon May 14, 2012 10:00 am
by Tinea Pedis
From what I can see, you can use a FSA Gossamer SRM with a CK BB? Would that be correct?

What about the k-force light?

Re: Chris King BB compatibility

Posted: Mon May 14, 2012 10:00 am
by Weenie

Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓    Broad Selection ✓    Worldwide Delivery ✓

www.starbike.com



Re: Chris King BB compatibility

Posted: Mon May 14, 2012 11:10 am
by sideshow_bob
I can't guarantee it, but you may be able to get the CK to work on the UT cranks.

I run a CK ceramic on my track bike, on the NDS there is a sleeve that converts the 25mm bearing to the 24mm on the Omnium cranks I use. I don't see why running this both DS and NDS wouldn't work ok. It runs perfectly fine on my track bike and spins nice, no complaints from me. YMMV.