Look 795 Blade

[naavt]

what handlebar/stem is that?

Integrated Yoeleo H9

https://www.yoeleobike.com/products/h9- ... -handlebar

Will any bar/stem work with integrating the cables?

Probably yes, in the event that you provide the changes I've also made.

You have to accommodate for the difference of the fork steerer (from rectangular to circular), and the spacers that have to receive all cables

[naavt]

I've already decided and I'm going the lighter route. Installing an Easton EC90SL with P2Max SL PM. Trying to shed some weight.

Can anyone point me in the right direction to really light and stiff thru axles for this bike? I've seen many here on WW raving about J&Ls but I don't know if they are compatible with the 795.

[rudye9mr]

https://robertaxleproject.com/product/l ... d-release/

34g for the rear

you can go through the selector for the front.

the mavic speed release axles are not that much off this weight either.

If you do use a wheel on trainer - you can also find axles here.

[naavt]

https://robertaxleproject.com/product/l ... d-release/

34g for the rear

you can go through the selector for the front.

the mavic speed release axles are not that much off this weight either.

If you do use a wheel on trainer - you can also find axles here.

Thanks! Had the idea - wrongly I suppose - that I could shave some more grams on this swap alone, but it seems not

[Renne]

what handlebar/stem is that?

Integrated Yoeleo H9

https://www.yoeleobike.com/products/h9- ... -handlebar

Will any bar/stem work with integrating the cables?

Probably yes, in the event that you provide the changes I've also made.

You have to accommodate for the difference of the fork steerer (from rectangular to circular), and the spacers that have to receive all cables

Where did you get spacers for this?

[naavt]

Where did you get spacers for this?

It's being designed.

It will be SLS printed, so perfectly smooth edges and NYLON PA12 materials used.

I can share the designers contact when its done for anyone with interest.

[Pew]

^ I'm definately interested! I was thinking about this last year but durability was my no. 1 concern. A hollow plastic spacer just doesn't seem all that strong

[Renne]

Where did you get spacers for this?

It's being designed.

It will be SLS printed, so perfectly smooth edges and NYLON PA12 materials used.

I can share the designers contact when its done for anyone with interest.

Could be interested!