Camera Mounts and Assorted 3D Printed Parts

[WheresWaldo]

@kode54, no I do not, and it isn't anything I am planning on doing. I have to do everything without help from bike manufacturers and I have too much on my plate at the moment.

[kode54]

@kode54, no I do not, and it isn't anything I am planning on doing. I have to do everything without help from bike manufacturers and I have too much on my plate at the moment.

No worries. Thx for the reply.

[WheresWaldo]

Uploaded with permission of the owner of this beautiful Pina.

[WheresWaldo]

Shapeways has just informed me that my marketplace shop has been selected for a week long Customer Success promotion starting Sunday May 2nd and going on through Saturday May 8th.

This would be for 10% off all plastic offerings from my Shapeways marketplace shop. Now would be the time to get that special mount you have been holding off on.

Use the code MadBike2021 at checkout. Pass it on to your riding buddies.

Please note that during this week long promotion I will not be taking on any custom requests for mounts.

Remember to use the code MadBike2021.

Visit http://www.shapeways.com/shops/revolutionaries

[renoracing]

Can't speak highly enough in regards to these products! I've not got four different products from the webstore and have had great luck with them all! Especially the most recent purchase... I reached out via Shapeways about getting a custom Varia mount designed for my 3T Strada seatpost... Two days later I had a 3D rendering sent to me, and a few days after that I had it in my hands! Thanks again!

[WheresWaldo]

@renoracing

It looks even better on the bike than it does in my CAD rendering software. I am glad you are happy with the design.

[glepore]

Any chance you could do a version of the single bolt 34.4 varia mount with a 35 mm diameter for my seatmast?

[WheresWaldo]

@glepore

What is the angle of your seat mast?

[glepore]

Meausres 26 degrees using an iphone level. Don't have exact geo for the bike.

[WheresWaldo]

@glepore

26° from what? It is usually measured from the ground, so should be in the 70°++ range. If it is 26° from vertical that would be super slack, like a 64° seat angle. That just can't be correct. Is it a recumbernt?

[glepore]

Typo. 16 degrees from vertical, which would make it a 74 degree sta.

[WheresWaldo]

@Glepore, it is done!
http://shpws.me/SGsE

[glepore]

Thanks and bought. Great resource you are.

[Crankycolnago]

@WheresWaldo, do you have a camera mount for the shimano stealth saddle ?

[WheresWaldo]

@Crankycolnago Can you post a picture of the saddle undersides?