Hi All
I have an brand new set of 900DB's that were takeoffs from my supersix and I want to press them into service as a set of cheap and cheerful (and heavy) gravel wheels so I can run 11 speed on my G bike. They come setup as 12mm as standard and there is not option for QR kits as they are a OEM wheel.
Does anyone know if it's possible to use a QR kit from another Fulcrum wheelset on these? It's unsure what hub they use or if it's the same as other 28 h hubs in the range
thanks in advance, D
Converting Fulcrum 900DB to QR
Moderator: robbosmans
I don't have experience of fulcrum/campy wheels but speaking from a general view:
It should be possible as long as the hubs aren't 142mm only. Remove the endcaps and measure the axle length. Is it feasible that other endcaps can produce a 135mm axle length? That's the question you want answered.
The front wheel is no problem.
It should be possible as long as the hubs aren't 142mm only. Remove the endcaps and measure the axle length. Is it feasible that other endcaps can produce a 135mm axle length? That's the question you want answered.
The front wheel is no problem.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
Good call, the axle tube is 140mm so unless I replace that as well it’s not going to happen. I think I’ll just bite the bullet and get a set of scribe gravel wheels which look quite attractive
Thanks for the tip
Sent from my iPad using Tapatalk
Thanks for the tip
Sent from my iPad using Tapatalk