Mr.Gib wrote: ↑Sun Sep 12, 2021 12:43 am
So what's the problem? It the Corsa to tight or too loose? If it won't jump up onto the bead shelf, mount it first with an inner tube, then remove the inner tube while leaving one side of the tire on the bead shelf, instal valve stem, and than hit it with an AirShot or similar.
It is too loose!
I tried with the inner tube, but the minute I deflate the tube, both sides come off the bead...
I don´t have an AirShot or similar... I have been using a CO2 cartridge or going to the gas station to use the compressor...
I did leave last night with the inner tubes on and put some sealant on the beads in the hopes that it will maybe hold in place when I deflate them... let´s see...
Will also try the thick soap (detergent?).
Thank you for the suggestions!
By the way, has anyone managed to mout this specific tubeless configuration? (CLX wheels with Vittoria Corsa Speed 2.0 Tubeless) How did it go?
Regards,
Daniel