Hey !
Figured I would do a specific post about my request
I've ordered 2 rims LB 56mm ultra wide for my aero disc bike
I care mostly about
- durability of bearings , ease of maintenance or nearly not maintenance at all
- geometry ( 15X100 and 12X142 front hub ) will use cx ray spokes and probalby some cx sprint or dt aerocomp on the free whel side to balance stifness , wont use round spokes as i am 1m88 and between 65 to 70kg
- price/weight
- after sales services if needed
I've selected 4 modeles of hubs, I won't build myself the rims, my wheelbuilder is really helpfull but conservative, I guess more opinions are better
I don't mind mixing brands if necessary but won't mix J bend and Straightpull hubs tough
- DT swiss 240S J bend : price ok , weight ok , durability and bearings protection ok , geometry average ?
According to my wheelbuilder Straightpull DTswiss have worse geometry than hope straighpull
I've used the spokes simulator with the ERD of the rims but I don't know if the numbers are better or not than hope or newmen ...
- Hope RS4 Straightpull : price ok , 50 to 60 gr heavier so it's acceptable , durability and bearings protection ok
geometry compared to DTswiss 240 J bend ?
- Hope RS4 J Bend : same
- Newmen Centerlock Straightpull : a little bit expensiver but still ok , way lighter , play settings seems ok not too difficult and seems to last from their mtb wheels with the same kind of hub I've read , bearings and weather protection seems okay . https://www.mtb-mag.com/en/tested-newme ... -wheelset/
Geometry in pictures :
So I've the numbers but I am not sure how to translate all this in - or +
What would you do in my situation ?
Thanks !
Disc hubs for LB 56mm ultra width rims
Moderator: robbosmans
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
I recently built a set of 24/28 spoke disc wheels using DT Swiss 240s j-bend rear hub, Hope RS4 straightpull front hub, CX-Ray spokes all round with DT Squorx nipples, Light Bicycle RRU25 carbon rims. Wheels haven't been in use all that long, but zero problems with them so far, and I have other sets of wheels using DT Swiss and Hope hubs which have been completely problem free. Built-up weight, according to my kitchen scales, with tubeless rim tape but without valves installed, is 650g front wheel and 780g rear wheel (1430g total).
-
- Posts: 573
- Joined: Sun May 06, 2018 8:30 pm
Hi thanks
I've had wheels in the past with straightpull DT350
Within a few months the anodisation was coming off where the spokes enters the hubs flanges
Except that nothing to complain about for the price , bearings are great ,
But if I can't get something a little bit better why not
Why the '' mismatch '' ?
Did you already had one of the hubs ?
I've had wheels in the past with straightpull DT350
Within a few months the anodisation was coming off where the spokes enters the hubs flanges
Except that nothing to complain about for the price , bearings are great ,
But if I can't get something a little bit better why not
Why the '' mismatch '' ?
Did you already had one of the hubs ?