got my first flat today..

Back by popular demand, the general all-things Road forum!

Moderator: robbosmans

addictR1
Posts: 1878
Joined: Sun Jun 10, 2012 1:11 am

by addictR1

usually i would bring a spare, but today's morning ride i forgot it... 36 miles in and i noticed the rear wheel making some weird noise. to my surprise..it's covered with cuts and glass. after removing the glass, i tried to fill it up with pitstop.. first time using that and turned out to be a mess. most got into the tub.. but other were all over.

is my veloflex sprinter done for? i counted a total of 7 cuts and punctures.
Attachments
32972215_10156348804597346_7399185059854417920_n.jpg
32980349_10156348804712346_3832483903306727424_n.jpg
33020520_10156348804342346_8207882502103105536_n.jpg
33040759_10156348804677346_6778986452257603584_n.jpg
33045014_10156348804377346_1345770917791268864_n.jpg
33066103_10156348804492346_8767943046340804608_n.jpg
33081702_10156348804452346_8001945219761176576_n.jpg
33116167_10156348804572346_318398368172736512_n.jpg
33141776_10156348804257346_4740692499398393856_n.jpg

1415chris
Posts: 1433
Joined: Sat Apr 18, 2009 8:59 am
Location: Surrey UK

by 1415chris

All of that after just one ride?
Assuming that you manage to seal the inner tube, some of the cuts you can close with super glue.
Rubber damage from first pic will leave a weak point anyway. Then the L shape cut. It will be very hard to glue it. Even if you manage to do that, it will not withstand the pressure and ride itself. The cut is just too big and the caracas may also be compromised.
In the best case you will end up with the bulge in this place.
You can give it a go, but imo it will be a waste of your time.
And advice on the sealant, I ditched Pitstop after my first two attempts. It wasn't messy, but simply it didn't work.
I had a good experience with No tubes and Orange.

by Weenie


Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓    Broad Selection ✓    Worldwide Delivery ✓

www.starbike.com



sungod
Posts: 1702
Joined: Fri Dec 24, 2010 9:37 pm

by sungod

pitstop is worse than useless, tufo extreme is the best i've found, works very well with veloflex, some say orange seal is as good/better

i've had veloflex tubs with way more cuts than that, as long as the tyre isn't bulging at a cut it's fine

with any cut that reaches the carcass, what tends to happen is it causes abrasion of the inner tube, eventually leading to a puncture, personally i would not put superglue in a cut, if it reaches the carcass it'll set it hard which is even more damaging to the inner tube

now that the tub has sealant in it, you need to avoid letting it deflate, if that happens the sealant can stick the inner tube to itself, then it'll fail when re-inflated

you can try putting some better sealant in and see if it holds, as long as there aren't bulges you can keep resealing if an old/new puncture opens up, sealants dry out over time, but if it's really worn it'll hole more easily and there comes a point where you could spend more on new sealant than the tyre is worth

with just a single puncture in a new/newish tub, i prefer to repair, but once it's worn i put sealant in as the return on time/effort is not so good if it's already worn,

addictR1
Posts: 1878
Joined: Sun Jun 10, 2012 1:11 am

by addictR1

Ok need to get me some new sealant and see if it will seal it up. I just tried to pump it up and it still leaks.


Sent from my iPhone using Tapatalk

User avatar
dj97223
Posts: 822
Joined: Sun Nov 06, 2005 7:27 pm

by dj97223

sungod wrote:
Mon May 21, 2018 1:20 pm
pitstop is worse than useless,
I've actually had good experience with PitStop. It can't fix large punctures, but used correctly (hold the can on the valve for a full minute), I think it serves its purpose.
“If you save your breath I feel a man like you can manage it. And if you don't manage it, you'll die. Only slowly, very slowly, old friend.”

addictR1
Posts: 1878
Joined: Sun Jun 10, 2012 1:11 am

by addictR1

got some orange seal today and filled about 2-3oz of it. spun it around for a while before pumping up. it squirted and wouldn't seal.
then saw on youtube ppl use crazy glue + patch. so i did that and so far it's holding at 125psi.... hopefully it will keep it sealed...
Attachments
1.jpg
2.jpg
IMG_0107.jpg

User avatar
pdlpsher1
Posts: 4013
Joined: Thu Jul 19, 2012 6:09 pm
Location: CO

by pdlpsher1

I think the superglue trick is meant to seal a tubeless tire. How can superglue seal a tubular tire as the leak is on the tube and not the tire itself?


Sent from my iPhone using Tapatalk

sungod
Posts: 1702
Joined: Fri Dec 24, 2010 9:37 pm

by sungod

addictR1 wrote:
Wed May 23, 2018 3:25 am
got some orange seal today and filled about 2-3oz of it. spun it around for a while before pumping up. it squirted and wouldn't seal.
then saw on youtube ppl use crazy glue + patch. so i did that and so far it's holding at 125psi.... hopefully it will keep it sealed...
your picture shows 'endurance' orange seal, it's different - i made the same mistake once, only found out later i'd got the wrong type

i think it is designed to stay liquid longer in tubeless applications before needing refill, but it does not seal as well when used to try and fix inner tubes

putting a patch on the outside may help by giving the sealant extra time/support while it dries in the hole, how it lasts out on the road will be the test, especially when hitting bumps

addictR1
Posts: 1878
Joined: Sun Jun 10, 2012 1:11 am

by addictR1

doh.. so from the sound of it.. looks like i got the wrong type of orange seal. so maybe this tubular is fubar?

ordered some tufo extreme from chain reaction. any point in putting those in or just save it for next time i have a flat on a different veloflex?

My lbs recommended the endurance version because it states it’s for tubular, whereas the original orange seal doesn’t.

Image

1415chris
Posts: 1433
Joined: Sat Apr 18, 2009 8:59 am
Location: Surrey UK

by 1415chris

Tufo Extreme is a problem fixer, not preventer, don't put it in till you have to.

sungod
Posts: 1702
Joined: Fri Dec 24, 2010 9:37 pm

by sungod

^^^this

for the tub with the orange seal in it, i'd just see how it goes, eventually the sealant will dry out, then should be ok to put tufo in it if it flats again - about one third of a bottle is enough

with tufo, it seals anything that can be sealed - including it's own nozzle, presta valves, valve stems - i carry a bit of plastic coated wire to unclog the nozzle

Geoff
Posts: 5395
Joined: Sat Dec 13, 2003 2:25 am
Location: Canada

by Geoff

Thats no fun.

In my experience, the best way to repair tubulars is to simply replace the tube. There are services that will do that for you. My personal recommendation would be to avoid sealants and the like for tubulars (althought I have been itching to try a can of Pitstop that I have been lugging-around for a long time now, just because). The 'enclosed' nature of the tubular 'environment' makes the use of such sealants less effective than in tubeless applications and causes a real mess for re-tubing later.

User avatar
Calnago
In Memoriam
Posts: 8612
Joined: Sun Nov 07, 2010 9:14 pm

by Calnago

@geoff: I’d chuck that canister of pittstop before you actually embarrass yourself trying to use it for the first time on the side of the road. Will spray foam everywhere and you may be lucky enough to get some in the tire but I doubt if you’ll be lucky enough to have enough pressure left in that canister to get it inflated. Best bet is liquid sealant, use at time of puncture (I don’t do the pre-emptive filling of a tube).
But speaking of embarrassing moments... yesterday I was bombing down a long very smooth relatively straight descent and noticed what seemed like a hop in my wheel but thought it was just uneven pavement. I eventually stopped to check and sure enough there was a hop in the tire, not the rim. Hmmm... that’s never happened before as I’m always really meticulous about my glue jobs. Eventually got home and left it for another day, this morning to be precise. Well, turns out that particular wheelset was not glued at all, I had just mounted some Veloflex on them as placeholders. So, I’ve had several rides now on those tires/wheels down some pretty fast curvy stretches that could have been disastrous had the tube came off. But it never did. Both front and rear, completely unglued, and here I am riding around on them up hill, downhill curves etc. There was some very light glue remaining on the rims from a previous four job but that’s it. Nothing on the tire at all and they both just peeled off easily once deflated. Now that I think back there were a couple of times recently that I recall the rear feeling a bit different, maybe a slight wobble, but never thought anything more of it till just now. And now that I think back some more, there was a set of wheels that I’d been meaning to glue but never got around to it. That’s because I mounted them in some rims and just put them on a bike to keep them out of the way for the time being. Ouch! And I’m really trying to stay injury free this year.
Colnago C64 - The Naked Build; Colnago C60 - PR99; Trek Koppenberg - Where Emonda and Domane Meet;
Unlinked Builds (searchable): Colnago C59 - 5 Years Later; Trek Emonda SL Campagnolo SR; Special Colnago EPQ

spdntrxi
Posts: 5782
Joined: Sat Jul 20, 2013 6:11 pm

by spdntrxi

you would be surprised how sometimes no glue actually holds.. I assisted a guy who had a flat on my recent Eroica california ride. This was a pretty rough and gravel descent route and he had a flat with about 20 miles to go. I just happened to have a tubular and a roll of tufo tape. His rim was clean.. no glue and he admitted this was his first ride with tubulars.
2024 BMC TeamMachine R Building
2018 BMC TImeMachine Road
2002 Moots Compact-SL- getting aero look makeover
2019 Parlee Z0XD - "classified"
2023 Pivot E-Vault - completed project, full Xplr package

AZR3
Posts: 997
Joined: Wed Sep 12, 2012 9:00 pm
Location: Az USA

by AZR3

Scary stuff for sure!

by Weenie


Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓    Broad Selection ✓    Worldwide Delivery ✓

www.starbike.com



Post Reply