Hi guys, just got my warranty replacent Enve 4.5 to replace my old 3.4 gen1's.
Cervelo S3 - 56cm
Zipp SL-Sprint stem.
Zipp SL-70 Aero bars - 42cm.
Enve 4.5.
Sram eTap group.
Dura-ace chainset with Stages gen2 pm.
What do you think?
Enve 4.5's - Cervelo S3
Moderator: robbosmans
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
-
- Posts: 11
- Joined: Mon Apr 23, 2018 12:39 pm
Good spot, it was actually all I had in the garage so not by design.
I used to use the specialized turbo tyre on the Enve 3.4's as they seemed very wide and the rear would rub the chainstays if i used a 25c GP4000 for instance. The Specialized are 24c which helps.
I used to use the specialized turbo tyre on the Enve 3.4's as they seemed very wide and the rear would rub the chainstays if i used a 25c GP4000 for instance. The Specialized are 24c which helps.
-
- Posts: 95
- Joined: Mon Sep 01, 2014 11:53 am
- Contact:
I've just picked up a second hand S3 frameset, so this thread has some great ideas for the build.
Did you have any problems with the eTap FD? I've read that on some pre-2018 S3's you can't mount it low enough to reach the chainset properly, especially if you use a 50 tooth big ring. What chainset are you using - 52/36?
Also, what's the total weight of your build?
Did you have any problems with the eTap FD? I've read that on some pre-2018 S3's you can't mount it low enough to reach the chainset properly, especially if you use a 50 tooth big ring. What chainset are you using - 52/36?
Also, what's the total weight of your build?
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com