Anyone tried the Fulcrum RACING QUATTRO CARBON clincher

Everything about building wheels, glueing tubs, etc.
alastairb
Posts: 103
Joined: Thu Dec 12, 2013 2:36 pm

by alastairb

Have the Speed 40s and very pleased with them..

Sent from my SM-G935F using Tapatalk


Pinguin
Posts: 19
Joined: Fri Nov 02, 2018 9:28 pm

by Pinguin

Are the Stickers of the 2018 Version under the Coating or get it to removal?


NCTales
Posts: 1
Joined: Tue Nov 20, 2018 4:06 am

by NCTales

I have had the Fulcrum Racing Quattro Carbon DB versions for about 11 months. I have had a couple of issues that I wonder if anyone else in the community has experienced:

1. After several visits to the LBS and the Fulcrum distributor, it seems impossible to remove a small amount of lateral side to side movement in the rear hub (it has been adjusted a number of times).

2. My LBS is just replacing the bearings on both wheels for the 2nd time this year (going with better quality this time). I have done around 7k kms so far this year. The LBS tells me the hubs are not sealed on the disc side which is allowing water into the bearings more readily. Not sure if this is common.

Anyone else experiencing either of these issues? Any ideas on solutions would be welcome.

Post Reply
  • Similar Topics
    Replies
    Views
    Last post