evan326 wrote:Did you buy the crank new? Just curious for future reference that I'd need to source washers too.
What else do you need to finish?
Yes the crank was new but through Fleabay so of course it came not in original box.. it appears that Sram had changed over from the wave washer to a turn style 5mm adjuster so I don't think the crank even comes with the wave washer anymore? Either way I would recommend the kit with washer and bearing covers.
Minus bar tape, seatpost, Seat, and bottle holders the bike is complete. I just took her around the block to check shifting with a load and it worked flawless. I'm very impressed with how light she is ending up..
These are my Pedals..
Picture of wave washer... how's it look?
And how it sits as if 5 mins ago just after my seatless ride
I would like to get the Seat on before slamming the stem and to also make sure I like the position of the shifters! If my seatpost comes Tuesday I might take her out on my 20 mile loop!
Any thoughts or suggestions?