CAAD10 Black Inc Di2

Who are you (no off-topic talk please)

Moderator: Moderator Team

Citizenfox
Posts: 220
Joined: Fri Apr 03, 2015 1:22 pm

by Citizenfox

Just found I have one of these, sort of, more to follow!

jamesgstewart
Posts: 1
Joined: Fri Jun 19, 2015 4:36 pm

by jamesgstewart

tcurtbike wrote:No worries.

I've already pressed the bearings so it makes it a bit difficult to see the inside of the BB shell.
Basically there are two holes on the rear of the shell through to the seat stays:
Image
Image

One hole on the top of the shell through to the seat tube:
Image

One large rectangular hole on the front of the shell through to the downtube:
Image
Image

and finally, two holes on the bottom of the shell:
Image

The rest is pretty straightforward:
Image
Image
Image

I'd say you might have some trouble drilling/'dremeling' holes in the BB shell, it is a pretty tight fit.


Did you ever end up having problems down the road since you completed this build with the internal wiring and any rubbing on the spindle?

tcurtbike
Best Freak bike poster
Posts: 426
Joined: Mon May 25, 2009 9:34 am
Location: VIC, Australia

by tcurtbike

Nope, I've had the SRM out for servicing and the hot glue has held everything in place nicely.

tcurtbike
Best Freak bike poster
Posts: 426
Joined: Mon May 25, 2009 9:34 am
Location: VIC, Australia

by tcurtbike

5 years later, still going strong.

Image

Post Reply
  • Similar Topics
    Replies
    Views
    Last post