Hi i have eps super record and the front mech shifts superb on the bike stand,but for some reason today the mech out on a ride sometimes would not change up onto the big ring after a few shifts it would go.
What i cant understand is it was only doing it now and again,any suggestions?do i need to re set and start again
Back home on the stand all good again, maybe its just a minor adjustment.
Any info would be good.

_________________
COLNAGO C60 SUPER RECORD EPS
ENIGMA EVADE DURA ACE 9000
VOLVO FH 12 480 BHP

Check all connections and make sure they are tight.
Also any humidity on the connectors.

You may want to do a master reset:

Insert the Magnet and hold both mode buttons for 30 seconds.
Remove the Magnet (the Power Unit LED should make a rapid flash green and then shutdown)
Redo the Zero Settings on the rear and front derailleurs.

Make sure you are not getting any diagnostic lights......

_________________
www.royalbicycles.com

Thanks i will try that

_________________
COLNAGO C60 SUPER RECORD EPS
ENIGMA EVADE DURA ACE 9000
VOLVO FH 12 480 BHP

tried ? it worked ?

_________________
http://eliflap.it/