Sram red crank puller

Back by popular demand, the general all-things Road forum!

Moderator: robbosmans

Post Reply
ninjanoir78
Posts: 168
Joined: Sat Jul 19, 2008 8:14 pm

by ninjanoir78

hi, I have a sram red press fit bb30 crankset.. and could you tell me what kind of puller I need to remove the arm and crank??

thank you

I dont need the best one... the bolt is 10mm hex on the crank
Ninja

Cosmo
Posts: 99
Joined: Sun Feb 25, 2007 5:05 pm
Location: Netherlands

by Cosmo

Crank bolt is a self extractor-no puller needed.
after 2 drinks I'm a loser, after 3 a star

by Weenie


Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓    Broad Selection ✓    Worldwide Delivery ✓

www.starbike.com



sungod
Posts: 1702
Joined: Fri Dec 24, 2010 9:37 pm

by sungod

^^^this

use the 10mm hex, it will start, then get harder to turn as the extractor engages, keep turning and it will get easier again

ninjanoir78
Posts: 168
Joined: Sat Jul 19, 2008 8:14 pm

by ninjanoir78

Cosmo wrote:Crank bolt is a self extractor-no puller needed.


yes but the arm is usualy hard to remove
Ninja

sungod
Posts: 1702
Joined: Fri Dec 24, 2010 9:37 pm

by sungod

there is no puller, you just have to undo the bolt to release the two parts of the crankset

if you mean that you have undone the bolt but cannot get the spindle out of the bearings, use a rubber hammer (or put a book between metal hammer and spindle) and gently tap the end to drive it out

see sram's instructions if you are not clear as there are plenty of pictures showing what to do, they are on the sram website

ninjanoir78
Posts: 168
Joined: Sat Jul 19, 2008 8:14 pm

by ninjanoir78

thank you
Ninja

by Weenie


Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓    Broad Selection ✓    Worldwide Delivery ✓

www.starbike.com



Post Reply