hi, I have a sram red press fit bb30 crankset.. and could you tell me what kind of puller I need to remove the arm and crank??
thank you
I dont need the best one... the bolt is 10mm hex on the crank
Sram red crank puller
Moderator: robbosmans
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
-
- Posts: 168
- Joined: Sat Jul 19, 2008 8:14 pm
Cosmo wrote:Crank bolt is a self extractor-no puller needed.
yes but the arm is usualy hard to remove
Ninja
there is no puller, you just have to undo the bolt to release the two parts of the crankset
if you mean that you have undone the bolt but cannot get the spindle out of the bearings, use a rubber hammer (or put a book between metal hammer and spindle) and gently tap the end to drive it out
see sram's instructions if you are not clear as there are plenty of pictures showing what to do, they are on the sram website
if you mean that you have undone the bolt but cannot get the spindle out of the bearings, use a rubber hammer (or put a book between metal hammer and spindle) and gently tap the end to drive it out
see sram's instructions if you are not clear as there are plenty of pictures showing what to do, they are on the sram website
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com