BB92 pressfit BB + spacer?
Moderator: Moderator Team
I have got a UniTi BB92 pressfit BB for my bike - it comes with a spacer. I have tried mounting it with the spacer but there seems to be some play.
Do any of you use spacers with your BB92 pressfit BB?
Thanks
Do any of you use spacers with your BB92 pressfit BB?
Thanks
- eliflap-scalpel
- Posts: 870
- Joined: Sun May 25, 2008 10:12 pm
- Location: italy
- Contact:
put other shims to eliminate play and don't care about others ....
ciao Mads
ciao Mads
http://eliflap.it/
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
Other shims and don't care about others? Andrea - how many spacers are that? 2?
- eliflap-scalpel
- Posts: 870
- Joined: Sun May 25, 2008 10:12 pm
- Location: italy
- Contact:
sorry ...i red you post but my brain red crank not BB .....
try the "gold paper" , thin copper film
try the "gold paper" , thin copper film
http://eliflap.it/
Got a standard bb92 from Sram that fits. Gonna have a talk with UniTi because the cup in the driveside was way to loose.
- crazyeddie
- Posts: 74
- Joined: Sun Jan 26, 2003 8:32 pm
- Location: Saarbrücken/Germany
- Contact:
you have to use the 2,5mm spacer on the drive side, if your bottom bracket shell is 89,5mm wide.
Yes - used the spacer. I have located the problem to the cup in the driveside is too small. The Sram fits perfectly with no play but a bit heavier than the UniTi. I'm in contact with the shop so I hope for a good solution.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com