Can I run a BB30 bottom bracket without seals?

Discuss light weight issues concerning road bikes & parts.
Post Reply
Posts: 52
Joined: Mon Nov 05, 2007 12:38 am

by polar8

I bought a used CAAD10 frame and the bottom bracket seals were missing, presumably they fell off or stayed attached to the crank. Can I still use the bottom bracket? If not, I'll buy a new one and I have another question: I have a sram red quarq, do I need to use the sram bb or will any brand do?

Posts: 576
Joined: Wed Jul 08, 2009 9:19 pm

by Doolop

No. Buy a new bottom bracket. They are cheap.

by Weenie

User avatar
Posts: 1374
Joined: Fri May 12, 2006 2:11 pm
Location: Stockholm, Sweden

by cerro

Get a new bottom bracket I say too. Every BB30 is the same so brand doesn't matter.
/jonas l (my cyclingblog)

User avatar
Posts: 853
Joined: Tue Aug 08, 2006 1:41 pm
Location: The Netherlands

by SWijland

The seals are not necessary, they just prevent dirt from getting into the bearings. So you should be able to use them.

Posts: 1416
Joined: Fri Dec 24, 2010 9:37 pm
Location: it's raining, it must be uk

by sungod

you can run without seals, but...

if you ride in wet weather, or dusty/dirty conditions, you will need to reduce time between servicing, strip, clean, regrease, or bearing life will be reduced

my experience is that not all bearings sold for bb30 are equal, i've had a set that were very slack on the axle, this caused fretting within just an hour, took them off, won't use them again

i never has this problem with sram branded bearings

Posts: 451
Joined: Thu Mar 26, 2009 11:06 pm
Location: Yorkshire - God's Own Country

by Svetty

Stick some tape over the ends! :D

Posts: 2196
Joined: Tue Nov 11, 2003 9:47 pm
Location: Santa Cruz, California, USA

by eric

If the seals on the bearings themselves are missing you need new bearings. But it's probably the secondary external seals that are missing. Those are less important. Unless you're riding off road or in the rain a lot you don't need them.

Few people regrease sealed bicycle bearings. Getting the seal off and back on without damaging it is a bit tricky on these small bearings with narrow seals. It's much easier on larger bearings with larger balls and thus larger seals.

by Weenie

Shop Owner
Posts: 1980
Joined: Sat Jun 13, 2009 4:02 am
Location: NoVA/DC

by thisisatest

The "seals", the bearing shields, are necessary in the sense that you need them to space the crank properly. You can also use some other method to keep it spaced.
Bike shops can sell you just the shields. If the bearings are at all questionable, just replace them.
as far as fretting, I've found that that is most often caused not by tight or loose fit, but by bearing misalignment. FSA makes a bearing alignment checker for bb30 that I wish was more available. the fretting is usually accompanied by marks on the spindle that are sinusoidal, indicating that the bearing is crooked.
Just my 2cents

Post Reply
  • Similar Topics
    Last post