I seem to have lost the pinch bolt on my 3D+ crankset. Does anybody know where I can buy a new one?

_________________
-----------------------------
I like Spanish bikes and cars. Riding an Orbea Orca and a Seat Ibiza.

Do Rotor not say that this should never be removed? I may be wrong but it rings a bell. Might be worth asking them

I thinks ok to remove it. I stripped one and was unable to find a replacement bolt. Ended up just getting a new adjuster ring. http://www.velotechservices.co.uk/shop/vclose2.asp?prd=113829&cat=7386000657

_________________
My Cervelo R5
My Cervelo S3
My MTB

You're thinking of the 3d crank, without the "+". In that case, yes, it should not be removed and would be difficult to do so if you wanted to.
the 3d+ crank has a tiny screw on its preload collar. That can be replaced if you can find one.
I'd try hobby shops with r/c models. they use very small metric hardware.

Fair enough, apologies for the confusion!

Just give a call to ROTOR. I snapped the head off mine the first time I did an install of one, and they sent me one right out.

_________________
Life's too short to ride clinchers.

Parlee Z-Zero ISP

I have also lost my pinch bolt, and would rather not have to buy the whole preload nut assembly. Can someone tell me the specs for just the pinch bolt?

Thanks.

_________________
My favorite components are the ones I never have to think about.

Hey, I've lost one too ...