Valve lock on a tubie
Moderator: robbosmans
Have a slight problem which I hope WW's can help with. I am using Vittoria CR tubies that do not have removable valve core or screw off at the tyre that allows for a complete valve extension change out to the right length. I thought that I had left the valve sufficiently screwed open when putting on the extension but over time( 3 months) it has worked its way closed meaning I cannot pump it up. Obviously I would prefer not having to rip it off and was wondering if there is some nifty way or securing the top of the valve through the extension that would allow me to screw it back open again.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
That is exactly the reason we don't use them. While the 'right' answer is to remove the tire and re-do it with a 'proper' extender, the smart thing to do is to try to open the valve.
Try to unthread the valve extender. If you can't do it easily, don't force it, you could damage the interface between the valve and tube. I did this for a neighbor before (Tri-geek) with a small wooden dowel with a little tubular glue on it. It worked. Fortunately (unfortunately) he promptly rode through a whole pile of broken glass in the alley behind his house and cut his race tires to ribbons (doctors)! He learned not to ask the LBS to do that work...
Try to unthread the valve extender. If you can't do it easily, don't force it, you could damage the interface between the valve and tube. I did this for a neighbor before (Tri-geek) with a small wooden dowel with a little tubular glue on it. It worked. Fortunately (unfortunately) he promptly rode through a whole pile of broken glass in the alley behind his house and cut his race tires to ribbons (doctors)! He learned not to ask the LBS to do that work...
topeak valve extenders have an internal "tube" designed for exactly this situation. They open and close the valve screw even when the extender is fitted. However, you can usually achieve the same with a thin but rigid plastic tube, like you get with spray lubes etc. You just need to open up or widen the end a bit to fit tightly over the valve screw.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
-
- Shop Owner
- Posts: 1980
- Joined: Sat Jun 13, 2009 4:02 am
- Location: NoVA/DC
Mavic has extenders that are specifically designed to be flipped around to screw/unscrew the presta valve. it grips them just right.
Next time, though, you should "jam" the valve open by unscrewing the valve nut a little further than you normally can by hand (ie turn w pliers 1/8 of a turn more).
Next time, though, you should "jam" the valve open by unscrewing the valve nut a little further than you normally can by hand (ie turn w pliers 1/8 of a turn more).