willier cento 1 superlagera bb question.
Moderator: robbosmans
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
Is the Clavicula a regular BSA crank? If so, you need different bearings that press into the BB and a little plastic spacer/collars that go between the crank axle and the bearings. You can get the spacers from a Wilier dealer. The bearings are size 6805. If the crank is not a standard BSA, I don't think it will work.
Yes, its the standard bsa bb. The other photo shows 6806 bearing.
Now i concern about the length of the bb, it seems shorter then expected. the end part that the arm goes in are shorter.
Did you have any photo shows after installation? anyone done before?
Now i concern about the length of the bb, it seems shorter then expected. the end part that the arm goes in are shorter.
Did you have any photo shows after installation? anyone done before?
Passoni Mirror
Passoni Xxti
Passoni Xxti
-
- Shop Owner
- Posts: 1980
- Joined: Sat Jun 13, 2009 4:02 am
- Location: NoVA/DC
It will not fit.
Hit up the guys @ twohubs.com; they managed to install the Clavicula on Wilier frames (Zero 7 & Cento Uno).
http://twohubs.com/news.aspx?showarticle=169
http://twohubs.com/news.aspx?showarticle=169
-
- Shop Owner
- Posts: 1980
- Joined: Sat Jun 13, 2009 4:02 am
- Location: NoVA/DC
the Cento1 at Twohubs is the SR version. That, and the Zero7, have 386evo bb dimensions, for a 30mm spindle 86mm long. The original Cento1 is basically bb86/bb90, which is for a 24mm spindle. there's just not enough room on this one.
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com