Hi,

Any advice would be appreciated. Basically I want to use a Rotor Power 3d+ Crankset (with the Micro Adjust Spider) and the new SRAM Red Yaw Chainrings.

From what I understand I would need the SRAM Red non-hidden bolt chainrings as these just work with 5 bolt cranksets (not the new exogram one).

If anyone could tell me if this is possible I would greatly appreciate it, I can't find any info on using non-Rotor chainrings on their Micro Adjust Spider setup.

Thanks

I'm afraid I can't answer your question but have you actually got a Rotor Power yet? If so - photos pls:)

Not yet, was just about to order one. (They're out in February). They have the same chainring mount as the rotor flow though if that helps anyone.

You shouldn't have an issue.. it's just another front derailleur.

Sorry if I wasn't clear...question is can SRAM yaw chainrings be fitted to a Rotor power crankset with the micro-adjust spider.

Not if a sram derailleur will work with rotor chainrings.

Boy, I would give Rotor a call. They are pretty good with customer service and have a lot of qualified guy's on hand to answer any question.

Just get Praxis rings and call it good.

This. I have ordered 4 different sets up Q-Rings from Rotor USA over the phone and they always seem to pick up the phone before the phone has rang twice. They are in Boulder so no worries about any language barriers. Give them a call.

_________________
R5 VWD | 2008 SRAM Red | Rotor 3D+ SRM | Zipp 101s/Enve 3.4s
S5 Team | 2012 SRAM Red | Rotor 3D+ SRM | Enve 6.7s
P3C | Zipp Vuka Aero/R2C | Omega | FSA SRM | Zipp 808/Super 9 Disc
T1 | Scatto | Rolf Prima FX58